Automatic loading robotic arm for molding press machine-MD8-65-F-V

1

Basic parameters

power source

Power supply: single-phase 220V; rated power: 2KW

Compressed air: 0.55MPa±5%; 50L/min

Mold specification

Diameter: φ15~φ65mm; Height: 20 ~60mm; Square mold: 50×50mm

Scope of application: one mold and one hole (claw type, optional top pen device)

Two holes in one mold, three holes in one mold, four holes in one mold, six holes in one mold (vacuum adsorption type) Note: It is a multi-hole suction method

Dimensions

1600(L)×1300(W)×2100(H) ; Approx. weight: 820kg

3

drive mode

High precision electric cylinder cylinder

High-precision electric cylinder and SMC cylinder

4

Processing cycle

around 60s

Depending on the processing model

5

Tray capacity

finished tray

One layer, can hold 15 small rings 140×90

preform tray

One round layer, diameter 475mm can hold four 150×130

Defective product tray

140mm×90mm

6

Air purification

FFU fan unit

Realize the air repurification of the small environment of the equipment

7

visual system

vision

Monitor the cosmetic condition of molds and lenses

8

Mold, lens and preform transfer

transfer

Transfer of molds, lenses and preforms using pneumatic cylinders, pneumatic fingers, electric cylinders, error correctors and through-beam photoelectric sensors

9

Environmental
requirements

humidity

30-60% , but no condensation

temperature

Normal temperature 20-28°C, but no condensation